Product ID:LAGGING ADHESIVE &COATING 713 WHITE & RED
MSDS Date:04/16/1998
FSC:8040
NIIN:01-101-3866
Status Code:A
MSDS Number: CLNWZ

VIMASCO CORP

NITRO, WV 25143
US

Emergency Phone: 304-755-3328

Info Phone: 304-755-3328

Preparer: ERNEST CARTER

Cage: 14947

VIMASCO CORP

516 NITRO, WV 25143 US

Telephone: 304-755-3328

Cage: 14947

ETHYLENE GLYCOL

CAS: 107-21-1

RTECS: KW2975000

EPA Report Quantity: 1 LB

DOT Report Quantity: 1 LB

VINYL ACETATE-DIBUTYL MALEATE POLYMER

CAS: 25035-90-9

HEXYLENE GLYCOL

CAS: 107-41-5

RTECS: SA0810000

CHLORINATED PARAFFIN

CAS: 63449-39-8

RTECS: RV0450000

Health Hazards Acute and Chronic:ETHYLENE GLYCOL: CAN CAUSE SKIN AND
EYE IRRITATION. EXCESSIVE INHALATION CAN CAUSE NASAL AND
RESPIRATORY IRRITATION.INGESTION CAUSES DRUNKENNESS, RAPIDLY
PASSING INTO COMA, WITH SERIOUS KIDNEY INJURY AND/OR DEATH.
Medical Cond Aggravated by Exposure:PERSONS WITH PRE-EXISTING LUNG
DISORDERS MAY BE MORE SUSCEPTIBLE.

First Aid:SKIN: WASH WITH SOAP AND WATER. EYES: FLUSH WITH CLEAN WATER
AT LEAST 15 MINUTES, IF IRRITATION PERSISTS, CONSULT PHYSICIAN.
INHALATION: REMOVE TO FRESH AIR.IF BREATHING IS DIFFICULT,
ADMINISTER OXYGE N. IF IRRITATION PERSISTS, CONSULT
PHYSICIAN.INGESTION: GIVE TWO GLASSES OF WATER, INDUCE VOMITING,
CONSULT PHYSICIAN OR POISON CONTROL CENTER, NEVER GIVE ANYTHING BY
MOUTH TO AN UNCONSCIOUS PERSON.

Flash Point Method:TCC
Flash Point:=100.C, 212.F
Extinguishing Media:FOAM, ALCOHOL FOAM, CO2, DRY CHEMICAL, WATER FOG.
Fire Fighting Procedures:PRODUCT WILL NOT BURN UNTIL WATER HAS BOILED
OR EVAPORATED.

Spill Release Procedures:VENTILATE AREA. CONTAIN THE LIQUID WITH INERT
MATERIALS SUCH AS SAND.ABSORB LIQUIDS USING AN INERT MATERIAL AND
SHOVEL INTO CONTAINERS. PREVENT PRODUCT FROM ENTERING STREAMS OR
DRINKING WATER SUPPLIES . BEFORE DRYING, PRODUCT MAY BE WASHED AWAY
WITH WATER, AFTER DRYING REMOVE WITH A PAINT SCRAPER OR STRONG
SOLVENT. SPILLED PRODUCT MAY BE SLIPPERY, WEAR NON-SKID FOOTWEAR.

Handling and Storage Precautions:USE WITH ADEQUATE VENTILATION. STORE
INDOORS AT TEMPERATURES OF 45 F TO 90 F .
Other Precautions:FOR INDUSTRY/PROFESSIONAL USE ONLY.

Respiratory Protection:IN RESTRICTED VENTILATION AREAS,USE APPROVED
CHEMICAL VAPOR RESPIRATOR. IN APPLICATIONS WHERE MISTS OR SPRAY MAY
BE GENERATED, AVOID INHALATION OF AIRBORNE PARTICULATES BY USING AN
APPROVED RESPIRATOR WITH ORGANIC VAPOR CARTRIDGE WITH PREFILTER
FOR MIST OR DUST.
Ventilation:GENERAL (MECHANICAL) ROOM VENTILATION IS EXSPECTED TO BE
SATISFACTORY.
Protective Gloves:IMPERVIOUS GLOVES.
Eye Protection:GOGGLES, FACESHIELD, OR OTHER EYE WEAR TO PROTECT FROM
SPLASH.
Work Hygienic Practices:THOROUGHLY CLEANSE HANDS AFTER HANDLING.
Supplemental Safety and Health

Boiling Pt:=100.C, 212.F
Melt/Freeze Pt:=-3.7C, 25.F
Decomp Temp:=115.6C, 240.F
Vapor Density:LIGHTER
Spec Gravity:1.29
VOC Pounds/Gallon:575
pH:8.0 TO 9.0
VOC Grams/Liter:.48
Viscosity:75,000
Evaporation Rate & Reference:SLOWER THAN ETHER
Solubility in Water:APPRECIABLE
Appearance and Odor:VISCOUS, WHITE OR RED PASTE WITH MILD LATEX ODOR.
Percent Volatiles by Volume:60%

Stability Indicator/Materials to Avoid:YES
MATERIALS INCOMPATIBLE WITH WATER.
Hazardous Decomposition Products:WILL YIELD CO, CO2, HCI,
ANTIMONY-OXYCHLORIDE, AND FRAGMENTED SHORT-CHAIN HYDROCARBONS.
Conditions to Avoid Polymerization:WILL NOT OCCUR.

Waste Disposal Methods:IN ACCORDANCE WITH ALL APPLICABLE REGULATIONS.

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.